Ads Forum - Expanded Thread Page

Subject: Front end loader driver for crankshaft pulley

[Back] [Return to Top of Forum]

poderac    Posted 11-04-2019 at 09:08:46 [URL] [DELETE]        [Reply] [No Email]  
  • Front end loader driver for crankshaft pulley
  • I wanted to move my FEL from my 641 gas to my 3000 diesel, but the piece that bolts to the crankshaft pulley bolts are too close together. Does anyone know how far the 4 bolts are apart on a 3000 diesel crankshaft pulley, and does anyone have one for sale?
    The shaft is a 10 spline.

    Bruce Dorsi    Posted 11-06-2019 at 08:10:14 [URL] [DELETE]        [Reply] [Email]  
  • Re: Front end loader driver for crankshaft pulley
  • Click the link.

    poderac    Posted 11-06-2019 at 13:04:07 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Front end loader driver for crankshaft pulley
  • Yes, that helps tremendously. Now for a technical question.
    My hub is 7/8 between the points of the splines. The splines are 1/16 inch high. That means the hub is 1 in. between the valleys. Do they consider that a 7/8 or 1 in. shaft?
    Thank You

    John in Mich    Posted 11-06-2019 at 14:09:10 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Front end loader driver for crankshaft pulley
  • I always used the major OD as the diameter so that would be a one inch splined shaft.

    poderac    Posted 11-06-2019 at 14:11:51 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Front end loader driver for crankshaft pulley
  • OK. Thank You, John.

    [Back] [Return to Top of Forum]


    Top