Implements Forum - Expanded Thread Page

Subject: dog gone bones

[Back] [Return to Top of Forum]

Tom2015    Posted 06-10-2016 at 21:12:20 [URL] [DELETE]        [Reply] [Email]  
  • dog gone bones
  • Hey folks. Did a little trimming with the 14-15 mower today. Worked fine without incident. A couple hours later it dawned on me that I never put the "dog bones" on. So, what is their purpose?

    KCM    Posted 06-20-2016 at 20:06:02 [URL] [DELETE]        [Reply] [No Email]  
  • Re: dog gone bones
  • Seem to remember that is they are not installed, the mower will raise too high and the PTO shaft will separate where it slides. Might also put too much of an angle on the u-joints. The dog bones just reduce the amount of lift off the ground by essentially shortening the stroke of the lift piston.

    Tom2015    Posted 06-20-2016 at 21:37:59 [URL] [DELETE]        [Reply] [Email]  
  • Re: dog gone bones
  • You're right. Guess I got away w ith something. I only use this for trimming around where my moco wont go.

    Dave in Wisconsin    Posted 06-13-2016 at 16:04:18 [URL] [DELETE]        [Reply] [No Email]  
  • Re: dog gone bones
  • I had some dog bones that I had no need for so I got me a dog....

    Jack - Iowa    Posted 06-12-2016 at 09:32:49 [URL] [DELETE]        [Reply] [Email]  
  • Re: dog gone bones
  • I do not remember ever using those on a 9N or 2N. May be necessary on a 8N.

    However my memory is not what it once was!

    Ed Gooding (VA)    Posted 06-12-2016 at 08:40:02 [URL] [DELETE]        [Reply] [Email]  
  • Re: dog gone bones
  • From the owner's manual in our library here:

    Tom2015    Posted 06-12-2016 at 09:09:14 [URL] [DELETE]        [Reply] [Email]  
  • Re: dog gone bones
  • Thanks for the reply. I have the dog bones, I just forgot to put them on. Didn't make any difference. The mower worked fine. I have that manual too.

    [Back] [Return to Top of Forum]


    Top