N Board Forum - Expanded Thread Page

Subject: Adding timing marks

[Back] [Return to Top of Forum]

Dave Smith    Posted 11-14-2017 at 16:27:04 [URL] [DELETE]        [Reply] [Email]  
  • Adding timing marks
  • In the forum archives under timing marks you will see how I did it using a dial
    indicator with the head off.
    http://ntractorclub.com/forums/nboard/messages11/221777.html
    Another way I use to find TDC with the head on is with a ohmmeter
    A analog meter works best with a stiff piece of solid insulated copper wire.
    Bare both ends of the wire. Connect one end to the meter and connect
    the other meter lead to a good ground on the block. Insert the other
    bare end in to number one spark plug hole so it will touch the top of
    the piston. Make sure the piston is on compression stroke with both
    valves closed. (You can check that with you're finger over the plug hole)
    Very slowly turn the engine over forward. Watch the ohmmeter. as soon as the
    meter shows continuity. STOP Make a mark on the front pulley where you can
    see it easily. Continue turning the engine over slowly,
    When the meter shows you lost continuity STOP. Make another mark
    on the pulley. Dead center between these marks should be TDC.
    Do this a couple of times to be sure you have it right.
    Mark the pulley and the block there. I used a dremel tool.
    You have TDC marked. Now measure the circumference of the pulley
    and divide that by 360 deg. That gives you 1 degree, Multiply that by 4
    and make a mark on the pulley only BEFORE the TDC mark.
    That is where you want the spark plug to fire.
    If you're front mount distributer is in good condition and you
    static timed it, That is where it should fire.
    Incidentally, You can time it on either the no 1 piston or the
    number 4 piston. One piston firing the plug and the other piston
    finished exhaust stroke starting intake stroke.
    Also some side mount engines have 2 sets of timing marks 180 degrees apart.
    You can time it on any of the 4 power strokes. One set of timing marks for
    1 and 4 piston the other set for 2 and 3 pistons. Make sure you are using
    the right set of marks for the compression stroke.
    Dave <*)))><

    clayton ingmire    Posted 11-14-2017 at 16:56:50 [URL] [DELETE]        [Reply] [Email]  
  • Re: Adding timing marks
  • You can also use a degree wheel using a dial indicator on number one cyl. stop at .050 before tdc then adust pointer on degree wheel close to tdc reading then spin motor backwards till dial indicator reads .050 again and read wheel split the difference with the pointer this will give you tdc also for ingnition timing you can use the coil wire it will be 4 times as bright just my two cents

    JMOR    Posted 11-14-2017 at 17:22:19 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Adding timing marks
  • If you have head off. Why 4? Half those firings won't be when mark is in view.

    clayton ingmire    Posted 11-14-2017 at 17:47:59 [URL] [DELETE]        [Reply] [Email]  
  • Re: Adding timing marks
  • wrong guy you what top one

    JMOR    Posted 11-14-2017 at 18:37:27 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Adding timing marks
  • ?????????????

    [Back] [Return to Top of Forum]


    Top