N Board Forum - Expanded Thread Page

Subject: No start

[Back] [Return to Top of Forum]

Dave2N    Posted 05-28-2018 at 11:10:44 [URL] [DELETE]        [Reply] [Email]  
  • No start
  • My 1943 2N wont restart this morning. It's 12volt with Petronix ignition. I have a nice blue spark. Fuel is flowing to carb. After extended crank, fuel drips out of carb. Plugs are not wet. Won't even pop on ether. Changed cap, rotor and plugs. Removed carb. Bowl was full. Any advice would be appreciated

    Tim Daley(MI)    Posted 05-28-2018 at 17:19:21 [URL] [DELETE]        [Reply] [No Email]  
  • Re: No start
  • If'N ya got fuel, then Id start going thru the wring thoroughly...

    Tim Daley(MI)

    Dave2N    Posted 05-28-2018 at 21:41:37 [URL] [DELETE]        [Reply] [No Email]  
  • Re: No start
  • After many hours of bonding with The Ole Girl. After removing distributor twice and inspecting wiring, replacing coil wire, tightening all wires on ballast resistor. Two trips to TSC. There on the starter button ( positive feed to ignition switch) was a corroded terminal. Cut it back and replaced end. Fired right up.

    BlasterStumps    Posted 05-28-2018 at 22:14:28 [URL] [DELETE]        [Reply] [No Email]  
  • Re: No start
  • Nice work Dave! I admire your perseverance.
    Mike in CO

    [Back] [Return to Top of Forum]


    Top