N Board Forum - Expanded Thread Page

Subject: 720 loader brackets

[Back] [Return to Top of Forum]

Tom Hall    Posted 06-26-2018 at 17:39:14 [URL] [DELETE]        [Reply] [Email]  
  • 720 loader brackets
  • I'm looking at a Ford 720 loader that appears to be in good shape, includes pump and all brackets with exception of rear axle brackets. I'm not familiar with the loader parts and wondering if the brackets are relatively easy to locate, if mot I may pass on the loader. Thanks for any thoughts

    Tom Hall

    Tom Hall    Posted 07-07-2018 at 07:02:32 [URL] [DELETE]        [Reply] [Email]  
  • Re: 720 loader brackets
  • Thanks, I always worry about fabricating parts but so far all has turned out just fine so this should be no different.

    TheOldHokie    Posted 06-27-2018 at 08:37:42 [URL] [DELETE]        [Reply] [No Email]  
  • Re: 720 loader brackets
  • You will probably wind up having to make them or have them made. Not a hugely difficult DIY job.

    TOH

    Tom Hall    Posted 06-29-2018 at 12:08:52 [URL] [DELETE]        [Reply] [Email]  
  • Re: 720 loader brackets
  • Thanks TOH, are there any drawings/photos with measurements, I've looked around but nothing so far.

    Thanks again

    TheOldHokie    Posted 06-30-2018 at 05:58:41 [URL] [DELETE]        [Reply] [No Email]  
  • Re: 720 loader brackets
  • I don't know of any drawings but it should not be too hard to figure out what you need. I'd suggest you hang the loader up front, block up the rear arms, and break out a tape measure. Unless you are bent on matching the look of the original brackets some angle iron and/or rectangular tube should get the job done.

    TOH

    [Back] [Return to Top of Forum]


    Top