N Board Forum - Expanded Thread Page

Subject: Proof meter

[Back] [Return to Top of Forum]

Daniel Jinkens    Posted 10-31-2018 at 06:57:53 [URL] [DELETE]        [Reply] [Email]  
  • Proof meter
  • Just wondering if there is an easy way to determine if it is the proof meter cable, or proof meter itself that's not working? Thanks for any help.

    K.LaRue-VA    Posted 10-31-2018 at 21:02:04 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Proof meter
  • Usually the problem is with the cable. Remove the cable. Make sure the cable spins free in the jacket, and isn't twisted in half. Check both ends to see if they are not rounded-off. A new cable may fix the problem if the ends look badly worn. Before installing the old or a new cable, thoroughly clean all crud from the threads so both ends will thread all the way on. This has worked for me every time.

    The proof meter can be tested by spinning the input by hand. A small screwdriver may be needed to turn some of them. The needle should bob a bit, and the counter numbers should eventually turn.

    Farmer Dan    Posted 10-31-2018 at 09:17:15 [URL] [DELETE]        [Reply] [Email]  
  • Re: Proof meter
  • take the cable off the meter. start the tractor and see if the cable spins.

    [Back] [Return to Top of Forum]


    Top