N Board Forum - Expanded Thread Page

Subject: Control Arm Update

[Back] [Return to Top of Forum]

Kimberly    Posted 03-18-2019 at 11:08:53 [URL] [DELETE]        [Reply] [Email]  
  • Control Arm Update
  • I took the control arm to BIL and he used his shop press to straighten the control arm. It isn't perfect and the ball end is bent a bit; we did attempt to straighten it but was afraid we might snap it off. I am posting photos to see if the present condition is good to go; not sure the tolerance level here for proper operation. I will include the before photo as well for reference.






    Kimberly    Posted 03-19-2019 at 11:09:53 [URL] [DELETE]        [Reply] [Email]  
  • Is this OK or do I need to straighen it more?
  • Is this OK to use, the ball end is slightly off but afraid of snapping it off.

    [Back] [Return to Top of Forum]


    Top