N Board Forum - Expanded Thread Page

Subject: starter

[Back] [Return to Top of Forum]

jakester    Posted 08-02-2019 at 15:38:32 [URL] [DELETE]        [Reply] [No Email]  
  • starter
  • any tips on getting starter bendex out of the bell housing on a '48 8n besides breaking the tractor apart? Was having starter problems and went to remove it and evidently the pin in the end of starter was gone and bendex fell into the bell housing.

    Den N Ms    Posted 08-03-2019 at 01:20:53 [URL] [DELETE]        [Reply] [No Email]  
  • Re: starter
  • Jakester.#1 You might try a strong magnet on a flexible cable shaft like a choke cable (they make them) to carefully fish it out.
    #2 Remove the steering box and go through the top hole to fish it out.
    #3 You could let the sleeping dog lay,I have found as many as three in the clutch housing in one I split before,but I wouldn't suggest that one.
    #4 Split the tractor and grab it with your hand,and while in there check the starter ring gear for worn/missing teeth,flywheel surface,clutch disk,pilot bearing,pressure plate,throw out bearing replace?,and defiantly replace the transmission input shaft seal.While the input shaft is out use it to line your clutch disk up before bolting the pressure plate back up.

    Hopefully you will be able to fish it out of the starter hole,then replace it with a new improved clutch style Bendix drive.

    Shane    Posted 08-03-2019 at 10:13:55 [URL] [DELETE]        [Reply] [Email]  
  • Re: starter
  • Possibility?

    https://www.youtube.com/watch?v=-vwZ-gYYNJ0

    [Back] [Return to Top of Forum]


    Top