N Board Forum - Expanded Thread Page

Subject: HI, to everybody and I have a question

[Back] [Return to Top of Forum]

Beth and Allen    Posted 08-20-2019 at 13:01:53 [URL] [DELETE]        [Reply] [No Email]  
  • HI, to everybody and I have a question
  • First,It's been a long time since I've been on here,maybe a year. My job has been keeping me very busy, average 63 hours a week (glad I'm only part time).Thats another story.So here is my question how can I determine what the engine in our naa is originally from? I suspect it's originally from a stationary generator or pump.What numbers should I look for and where? I'm in the process of reassembling the tractor and old Wagner fel.I disassembled the whole thing about 11 months ago, totally redid everything on both, did a restoration and modernization on the tractor and fel, repainted everything and now putting it all back together.It's about %90 done and looking real good.Hope someone can clear up this mystery for me,God Bless, Beth and Allen.

    Ultradog MN    Posted 08-21-2019 at 03:48:36 [URL] [DELETE]        [Reply] [Email]  
  • Re: HI, to everybody and I have a question
  • Those engines were used in a lot of applications. Irrigation pumps, generators, wood chippers, swathers and the like. They built them till well into the 1970s - long after they stopped building tractors with them. I don't follow the Red Tigers that much but the fellows on the YT Ford Board might be able to help id it a little. Probably not what it was built For but When it was built and whether it is a 134, 172, 192, etc.

    R Geiger    Posted 08-20-2019 at 13:11:15 [URL] [DELETE]        [Reply] [No Email]  
  • Re: HI, to everybody and I have a question
  • The Industrial motor in my 8n had a data plate on top of the bell housing rather than a serial number in the usual place.

    Beth and Allen    Posted 08-20-2019 at 19:16:40 [URL] [DELETE]        [Reply] [No Email]  
  • Re: HI, to everybody and I have a question
  • I've had this tractor totally disassembled and haven't found any data plate.I'm guessing some of numbers that are cast into the block will tell the story but I don't know what I'm supposed to look for. Thanks,Beth and Allen.

    Kirk-NJ    Posted 08-22-2019 at 18:42:02 [URL] [DELETE]        [Reply] [No Email]  
  • Re: HI, to everybody and I have a question
  • Hi Allen
    Your Jub should have raised letters on right side lower section of the block EAE 6015 Date code is on left side of lower bLock. An industrial engine will have 2 Allen head bolts and plate towards front of engine for fuel pump. Post numbers you have. If done haul it to the Del valley show September 19/20/21

    [Back] [Return to Top of Forum]


    Top