N Board Forum - Expanded Thread Page

Subject: pto seal

[Back] [Return to Top of Forum]

Curby Perkins    Posted 10-10-2019 at 14:27:55 [URL] [DELETE]        [Reply] [Email]  
  • pto seal
  • I have a 1947 2N that needs the pto seal. I do not have a press and afraid to tackle the job. I see on YT that they have a complete shaft assembly. But they say it is a conversion assembly from 1-1/8 to 1-3/8 length 30-7/8. Will measure my shaft first. Question is, do you think I would be safe in ordering?

    Bruce (VA)    Posted 10-10-2019 at 16:03:01 [URL] [DELETE]        [Reply] [Email]  
  • Re: pto seal
  • Just replace the shaft.

    Curby Perkins    Posted 10-10-2019 at 17:34:08 [URL] [DELETE]        [Reply] [Email]  
  • Re: pto seal.
  • Thanks Bruce, and thanks for all the help I have received from you and this site. I haven't posted much on here but I have check here often and got answers to a lot of the questions on my 2N.
    I think my pto unit is original but just a little confused about the different sizes on the working end of shaft.(attaching to my brush hog).

    Richard NY 2N    Posted 10-10-2019 at 21:54:44 [URL] [DELETE]        [Reply] [Email]  
  • Re: pto seal.
  • All pto driven units made now are 1&3/8 size. Adapters are sold to go from original 1&1/8 to 1&3/8.

    Curby Perkins    Posted 10-11-2019 at 12:00:47 [URL] [DELETE]        [Reply] [Email]  
  • Re: pto seal.
  • Thanks Richard. That helped.

    [Back] [Return to Top of Forum]


    Top