N Board Forum - Expanded Thread Page

Subject: 19-97 Loader

[Back] [Return to Top of Forum]

UPTom    Posted 03-23-2020 at 09:55:16 [URL] [DELETE]        [Reply] [Email]  
  • 19-97 Loader
  • Good morning, I'm in the process of getting a Ford 19-97 FEL ready to mount on a 641 and am lacking a few pieces. I'm looking for the front support plate and the two support rods, I've come up empty at Messick's and online so hoping someone has the items or can provide dimensions of plate and locations of holes. There is a mounting plate currently on the loader but top portion was torched off so only two lower holes remain. I can weld new material onto existing plate as last resort but don't want to reinvent the wheel if I can the parts or measurements.
    Thanks in advance for any assistance
    Tom

    TheOldHokie    Posted 03-23-2020 at 13:01:49 [URL] [DELETE]        [Reply] [No Email]  
  • Re: 19-97 Loader
  • Not commonly available.

    The rods are trivial. You can substitute threaded rod or long hex bolts with some tube slipped over them as standoffs.

    The hanger plate is nothing special either. Weld what you need onto the one you have.

    Do you have the pump mount that bolts to the hanger? That is a little more complicated but not rocket science.

    TOH

    UPTom    Posted 03-23-2020 at 17:10:55 [URL] [DELETE]        [Reply] [Email]  
  • Re: 19-97 Loader
  • Thanks TOH for the response, I have the pump mount as it's welded to the current front hangar plate, not sure if this was a original Ford upgrade but eliminates the separate pump mount. I'll be out shopping for threaded rod and additional plate to add on to the hangar.

    Tom

    [Back] [Return to Top of Forum]


    Top