N Board Forum - Expanded Thread Page

Subject: hydraulics

[Back] [Return to Top of Forum]

Elijah Angney    Posted 04-05-2021 at 09:39:27 [URL] [DELETE]        [Reply] [Email]  
  • hydraulics
  • I was plowing with my 1940 9n this morning and it was going great, then all of the sudden the plow went deeper than I wanted and I got stuck. Anyways, I went to lift up the plow and it didn't budge at all, I unhooked the plow and the arms still didn't budge. Did the pump go bad? Or did something break? Or could the lever be loose?

    Thanks.

    Den N Ms    Posted 04-05-2021 at 12:04:48 [URL] [DELETE]        [Reply] [No Email]  
  • Re: hydraulics
  • Elijah Be sure the PTO is still engaged ans the shaft is turning when in neutral and the clutch is out.

    Elijah Angney    Posted 04-05-2021 at 14:15:24 [URL] [DELETE]        [Reply] [Email]  
  • Re: hydraulics
  • yes the pto was engaged.

    JMOR    Posted 04-05-2021 at 10:07:50 [URL] [DELETE]        [Reply] [No Email]  
  • Re: hydraulics
  • Remove round side cover & check for disconnected linkage.

    Elijah Angney    Posted 04-05-2021 at 20:13:11 [URL] [DELETE]        [Reply] [Email]  
  • Re: hydraulics
  • I took the cover off and found disconnection on the "wishbone" When I pop it back into place, the arms move again. I will drain the oil and take a closer look tomorrow. Any other suggestions?

    [Back] [Return to Top of Forum]


    Top