Re: Cam Follower Pin

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by JMOR on November 04, 2018 at 19:18:00 [URL] [DELETE] :

In Reply to: Cam Follower Pin posted by Jack - Iowa on November 04, 2018 at 17:26:11:

My nickel says, 0.309" dia X 7/8" length.

5/16 will be quite an interference fit at 0.3125 or 0.0035 tighter than intended, but there are claims of success.


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]