Re: temp. Gage censer location

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by Tim Daley(MI) on December 25, 2018 at 18:55:12 [URL] [DELETE] :

In Reply to: Re: temp. Gage censer location posted by Ed Gooding (VA) on December 25, 2018 at 07:47:43:

If you look closely at this photo Ed posted, just behind the LH front most cylinder head nut, the cast boss for the sensor is seen, right about where the red wire takes a bend. Many heads were cast, very few, if any, were machined and had the temp sensor installed.

Tim Daley(MI)


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]