Re: 9N Axle won't go all the way in

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by wer-fl on June 15, 2019 at 15:11:14 [URL] [DELETE] :

In Reply to: 9N Axle won't go all the way in posted by JP on June 15, 2019 at 12:57:27:

Lift the axle up above where is needs to be when sliding it in. The bearing could be hitting the inner race. It is about 1/4 inch from from fully seated when it is hits the race vs centered. Do not try to tighen the stud nuts to close the gap.


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]