Re: Question for member Gaspump

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by Gaspump on September 11, 2019 at 13:00:26 [URL] [DELETE] :

In Reply to: Re: Question for member Gaspump posted by SelectOSpeed on September 11, 2019 at 06:55:16:

Usually sheet metal went through a hot dip process. It cleaned, etched and lightly coated the metal. Casting were aged by time in process, cast at the Rouge, stockpiled, shipped as scheduled, stored at the tractor plant then machined. Castings too were run through a hot dip process, coated inside and out in the case of drive train housings.


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]