Re: donnahoo

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by Jack - Iowa on May 05, 2022 at 07:07:06 [URL] [DELETE] :

In Reply to: Re: donnahoo posted by frank on May 04, 2022 at 12:51:52:

Forget that 1/2 inch!

Spedifications vary dependent om the source but you shp\ould set it between .250 and .290

One member, who will rebuild a carb for others, uses a 9/32 drill bit as a guage.



Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]