brushogging with a 2N - How?

[ N Board Forum ] [ FAQ ]
Posted by Phil Warner on June 13, 2011 at 18:22:16 [URL] [DELETE] :

I got the 47 2N hydraulic fluid change finished today, decided to hook up the brush hog, and soon realized the catch 22 of 2N brush hog setup; can't spin the blades if it's on the ground and can't lift it without engaging the PTO. My hog's shaft is almost too long to remove with the lift arms attached, but I did finally got it off and lifted the brush hog (all the way up or all the way down only of course).


So how do you 2N guys set the height of your brush hogs. I seem to remember some comment about using chains, but I didn't see an obvious way to do it. Any photos of a good 2N brush hog setup?

Phil Warner in North West Arkansas

'53 Jubilee NAA18454
'53 Jubilee NAA39536
’47 2N *9N278814*


Follow Ups:

Subject: :

Posting not permitted in the forum archives.<1308007336">

[ N Board Forum ] [ FAQ ]