N Board Forum - Expanded Thread Page

Subject: 8n Wirst Pin bushings

[Back] [Return to Top of Forum]

Brian Good    Posted 03-03-2017 at 18:06:44 [URL] [DELETE]        [Reply] [Email]  
  • 8n Wirst Pin bushings
  • Help!
    Rebuilding the engine on my 8N. The machine shop assembled my rods and pistons. The holes on the sides of the rods do not go through to the wrist pin. The holes on the top line up correctly. I compared it to an old connecting Rod that I had. On the old connecting rod the the holes in the bushing line up and go through. The service training manual says to drill the hole. Looking for direction please!

    Rustyal    Posted 03-05-2017 at 19:15:51 [URL] [DELETE]        [Reply] [No Email]  
  • Re: 8n Wirst Pin bushings
  • Not sure which holes your referring to. You should not have to drill. The bearings allready have holes drilled. But it would not really hurt anything if you drill.

    [Back] [Return to Top of Forum]


    Top