N Board Forum - Expanded Thread Page

Subject: Jubileee throttle

[Back] [Return to Top of Forum]

Do_It_Yourselfer    Posted 10-22-2019 at 17:33:57 [URL] [DELETE]        [Reply] [Email]  
  • Jubileee throttle
  • I have Ford jubilee. Throttle does not work properly.
    I push up or down either way can increase or decrease my speed...no way to determine.
    I just move it one way or the other SLOWLY if it stares to decrease I push the other way slowly until it is at a speed where it will run the brush hog. While running it will eventually decrease speed on its own and stall out. I have to restart and do whole process over again.

    Any ideas on how to fix so it will work properly?

    Which direction is supposed to be for increasing speed?

    I thank you all in advance for any assistance you can provide.

    Douglas    Posted 10-23-2019 at 10:58:09 [URL] [DELETE]        [Reply] [Email]  
  • Re: Jubileee throttle
  • well its clear i wasn't thinking correctly lol, brain is fried i guess.

    Douglas    Posted 10-23-2019 at 09:07:48 [URL] [DELETE]        [Reply] [Email]  
  • Re: Jubileee throttle
  • should push up to increase throttle and pull back or down to decrease throttle. not sure what may be going on with your linkage.

    WayneIA    Posted 10-23-2019 at 10:36:24 [URL] [DELETE]        [Reply] [Email]  
  • Re: Jubileee throttle
  • Every Jubilee I ever saw, we pulled the throttle lever down, to increase engine speed and pushed the lever up to decrease engine speed. Better check the short connection under the battery box. May be getting the rod past center alignment with the friction pivot bolt.

    Ozlander    Posted 10-23-2019 at 10:49:47 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Jubileee throttle
  • What Wayne said.
    The same on all N series tractors and 600s and 800s.
    Up for slow, down for fast.

    [Back] [Return to Top of Forum]


    Top