N Board Forum - Expanded Thread Page

Subject: Shawnee front end loader question

[Back] [Return to Top of Forum]

Steve    Posted 12-30-2020 at 21:06:34 [URL] [DELETE]        [Reply] [Email]  
  • Shawnee front end loader question
  • I have a newly acquired Jubilee the has a large Shawnee front end loader. I will be using the tractor for mowing mostly in the summer and would like to remove it. It looks like there is a pin in a sleeve that is bolted to the axle that accepts the frame of the loader and an area at the front of the tractor that accepts the loader. My question is, the hydraulics pump for the loader assembly is connected to the front of the tractor. My guess is the engine crank. How do you disconnect that in order to remove the whole loader assembly?

    TheOldHokiehat you have to even hegin to guess how Shawnee    Posted 12-31-2020 at 04:22:39 [URL] [DELETE]        [Reply] [No Email]  
  • Re: Shawnee front end loader question
  • A number of different schemes were used by different OEMs. Need to see a picture of what you have to say for sure. The most popular setup was a splined hub bolted to the crankshaft pulley. A splined pump driveshaft fit into that hub and came out the front to power the pump. A flexible coupler of some sort was used to connect that shaft to the input shaft on the pump. Post pictures.

    TOH

    [Back] [Return to Top of Forum]


    Top