I have two vintage N series toplinks. These have an approx 12" steering wheel in the middle to adjust the length. It may be a Danuser. I am seeking replacement ends that allow for the pivoting in two directions, up and down and side to side. They have 3/4" holes in them. It looks like heavy duty one inch sections of pipe welded together on different axis. Except these are cast and look like cast iron. I know I can make them but thought I would ask if any exist out there as replacements before I go to the trouble? Thanks in Advance!sure wish there was an easier way to post a pic?

Interesting. Wonder how you keep the wheel from turning once you set your length? First time seeing this type top link.

Tyler

I like this one better than the two that I have with just a pin that can slide from side
to side and over time would fall out somewhere.

Click on the link and scroll down for a picture of the part in question.

• Link: https://ntractorclub.com/manuals/implements/blades/Danuser%2019-16%20All%20Purpose%20Blade-MPB.pdf