N Board Forum - Expanded Thread Page

Subject: Howard Reduction Gear

[Back] [Return to Top of Forum]

Jim    Posted 11-19-2026 at 14:35:27 [URL] [DELETE]        [Reply] [Email]  
  • Howard Reduction Gear
  • I found out that I have a Howard Reduction Gear lever on my 1947 8N. From what I have found out so far it is an aftermarket addition to these old tractors, if this is right. Does anyone have any experience with this function at all?

    Kirk-NJ    Posted 11-20-2026 at 03:05:33 [URL] [DELETE]        [Reply] [Email]  
  • Re: Howard Reduction Gear
  • Aftermarket usually installed at the ford tractor dealership. The Howard trans is not a shift on the go trans. You must be at a complete stop clutch pedal down low idle to engage.You can check out my videos on YouTube under Howard transmission

    Ed Gooding (VA)    Posted 11-19-2026 at 20:48:43 [URL] [DELETE]        [Reply] [Email]  
  • Re: Howard Reduction Gear
  • They were intended to be paired with the same company's Rotovater (tiller). It slowed the tractor to allow the tiller to turn the soil properly. They are rare, and I don't know if parts can be found for them. Many of the Reduction Gear units were damaged because owners would use them for non-tilling duties like pulling a stump, etc. We have an owner's manual for the Rotovator in our library here, and the reduction gear is mentioned.

    I have photos of the unit that I can post if there is interest.

    [Back] [Return to Top of Forum]


    Top