FERGUSON-SHERMAN CORDWOOD SAW

[ Follow Ups ] [ Post Followup ] [ Manuals Forum ] [ FAQ ]

Posted by Tim Daley(MI) on October 07, 2007 at 08:04:06 [URL] [DELETE] :

Here's a two-page flyer on the Ferguson-Sherman Cordwood Saw made for the 9N Ford Tractor. Note the attachment bracket and single leg. It's probable this was made by Dellinger as were most of the Ford saws. Also, if you decide to get a cordwood saw regardless of who made it, if you lift it to the transport postion as shown, you might want to remove your rear worklight and taillight before you do. Trust me, I found out the hard way by destroying an original frosted lamp worklight.

Ferguson-Sherman Cordwood Saw -Page 1

Ferguson-Sherman Cordwood Saw -Page 2

Tim Daley(MI)
*9N653I* & *8NI55I3*

Follow Ups:

Post a Followup:

Name    : 
E-Mail  : 
Subject : 

Comments:

Optional Link URL : 
Link Title        : 
Optional Image URL:

If you press "Preview Message," you are taken to a preview screen where your
message is shown to you before allowing you to post it.
Your message is not finalized until you click "Post Message".

[ Follow Ups ] [ Post Followup ] [ Manuals Forum ] [ FAQ ]