N Board Forum - Expanded Thread Page

Subject: ford Jubilee

[Back] [Return to Top of Forum]

Lem Hardy    Posted 12-21-2022 at 20:24:03 [URL] [DELETE]        [Reply] [Email]  
  • ford Jubilee
  • I removed the right trumpet from mu Jubilee to replace the lower lift link pin. I noticed that the Differential Bearing that runs on the race in the trumpet was worn and needs replacing. I also noticed that that part that the bearing on on is bolted on. How do I replace the bearing? Do I unbolt the part it is on? Do I have to cut the bearing off or just what is the best method of replacing the beating? Image 9727

    deanostoybox    Posted 12-25-2022 at 00:03:16 [URL] [DELETE]        [Reply] [No Email]  
  • Re: ford Jubilee
  • In order to remove and replace that bearing you need to remove the differential assembly. Good chance if one side is worn, the other side is too. I refer you to pages 24 and 25 of the FO-19 NAA service manual. Appears to be a scan of a photocopy, not easy to read. Paragraph 85 describes removal and installation of the differential assembly. Pay attention to the part about the gasket. Gaskets need to be the right thickness so the bearings have the right clearance. Also you may find the gaskets need to be wet in order to fit. Probably a good idea to have a couple extra just in case. No sealant.

    The FO-19 manual is available from here.

    When putting it together put the right axle housing on first. Then insert the differential assembly and hold it against the bearing race. While holding the differential against the race, jam a couple of wood wedges to hold it in place. Then insert the right axle. The weight of the axle will hold the differential in position and the wedges can be removed. Then the left axle housing can be installed. Then you will want to move on to paragraph 90, wheel axle shaft bearing adjustment.

    Have fun!

    Kirk-NJ    Posted 12-22-2022 at 06:23:08 [URL] [DELETE]        [Reply] [Email]  
  • Re: ford Jubilee
  • Have Jub rear with top cover for $200 if you need it in NJ 07838.

    Kirk-NJ    Posted 12-23-2022 at 16:16:26 [URL] [DELETE]        [Reply] [Email]  
  • Re: ford Jubilee
  • Can also pull any part you need

    Dn-N-Tn    Posted 12-25-2022 at 10:43:38 [URL] [DELETE]        [Reply] [No Email]  
  • Re: ford Jubilee
  • Sure wish I was closer to you----I could use the NAA rear and top cover, but East TN is a long way from NJ, Dennis.

    [Back] [Return to Top of Forum]


    Top