19-42 Dearborn Cylinder

[ Follow Ups ] [ Post Followup ] [ Implements Forum ] [ FAQ ]

Posted by Steve on November 09, 2026 at 19:38:25 [URL] [DELETE] :

I'm rebuilding a lift arm cylinder and have the packings for the upper und of the tube. Question is it;s a single acting cylinder and when I pull the shaft there is no lower packing just a Shaft Stop part #8 on the diagram part # 192126. How does this cylinder operate without a lower seal. By the internal look with weld tacks I cant imagine how a seal would last. How close of tolerance (diameter) is the Shaft Stop suppose to be. Mine is fairly loose 1.875" OD in a 2.0" ID Cylinder


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : ←http://www.yourwebsite.com Link Title : ←Website Title Optional Image URL: ←http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ Implements Forum ] [ FAQ ]