Re: Gasket Cutter

In Reply to: Gasket Cutter posted by PatrickB on January 08, 2016 at 12:38:59:

I'm thinking that if the shaft you used was extended by about 6" (opposite from the center point end), it could be secured in a 1/2" chuck on a drill press and then run at the slowest RPM speed available on the press, making it much easier to use.

Follow Ups:

• Re: Gasket Cutter - PatrickB 07:10:07 01/10/16 (0)

Name   : 
E-Mail : 
Subject: 

Message:

To add a single image to your post,  click here.
To add multiple images to your post, click here.

Optional Link URL : ←http://www.yourwebsite.com
Link Title        : ←Website Title
Optional Image URL: ←http://www.myimages.com/mypic.jpg

Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!